Actions

EmSys

Difference between revisions of "EK-TM4C123GXL LaunchPad Initial Board Setup"

From EdWiki

m (Connecting the board)
m (Connecting the board)
 
Line 8: Line 8:
 
===Connecting the board===
 
===Connecting the board===
  
[[image:tm4c123gxl_board_setup.png|center]]
+
[[image:tm4c123gxl_board_setup.png|right]]
  
 
[[File:ek-tm4c12gxl-board-setup.png |thumb|Tiva™ C Series TM4C123G LaunchPad]]
 
[[File:ek-tm4c12gxl-board-setup.png |thumb|Tiva™ C Series TM4C123G LaunchPad]]

Latest revision as of 17:42, 6 April 2022

Hardware Setup

Kit Contents

You should find the following in your box:

Connecting the board

Tm4c123gxl board setup.png
Tiva™ C Series TM4C123G LaunchPad

The TM4C123GXL LaunchPad Board ICDI USB port (marked DEBUG and shown in the picture below) is a composite USB port and consists of three connections:

  • Stellaris ICDI JTAG/SWD Interface - debugger connection
  • Stellaris ICDI DFU Device - firmware update connection
  • Stellaris Virtual Serial Port - a serial data connection


Using the included USB cable,

  • connect the USB emulation connector on your evaluation board (marked DEBUG) to a free USB port on your PC.
    A PC’s USB port is capable of sourcing up to 500 mA for each attached device, which is sufficient for the evaluation board.
    If connecting the board through a USB hub, it must be a powered hub.
  • The drivers should install automatically.


LaunchPad


Make sure that the power switch in the upper left hand corner of your board is in the right-hand DEBUG position as shown:



Start

  • Switch the POWER SELECT switch to the right for DEBUG mode.
  • Connect the USB-A cable plug to an available port on the PC and the Micro-B plug to the Debug USB port on the Board.
  • Verify that the POWER LED D4 on the board is lit.